Results (
Indonesian) 1:
[Copy]Copied!
1. Position belt with a link pin directly below the conveyor drive shaft.2. Hold a straightedge across the bottom of the conveyor discharge at the very rear.3. Using a 6-inch scale, measure vertically from the straightedge up to the underside of the belt.4. Push up on the underside of the belt and repeat the measurement as in step 3.5. Under the force applied by the average worker, the measurement in step 4 should be approximately 1/16 inch(1.5mm) greater than the measurement in step 3.
Being translated, please wait..