3. Take the master link out of the

3. Take the master link out of the roller drive chain between the clutch and motor and remove the chain.
4. Loosen the lock nuts on the belt tension adjusting screws (located just behind each of the pillow block bearings
on the drive shaft) and back off the adjusting screws until they are flush with the face of the adjusting bracket.
5. Loosen the two bolts holding each pillow block bearing.
6. Slide the drive shaft toward the tail of the conveyor as far as the adjusting slots for the pillow block bearings will
allow. This will provide maximum slack in the belt.

Results (Indonesian) 2:

3. Ambil link tuan dari rantai rol drive antara kopling dan motor dan menghapus rantai.
4. Kendurkan mur pengunci pada ketegangan sabuk menyesuaikan sekrup (terletak tepat di belakang masing-masing bantal blok bantalan
pada drive shaft) dan kembali dari sekrup penyesuaian sampai mereka rata dengan wajah menyesuaikan braket.
5. Kendurkan dua baut masing-masing memegang pillow block bearing.
6. Geser drive shaft menuju ekor conveyor sejauh slot menyesuaikan untuk bantal blok bantalan akan
memungkinkan. Ini akan memberikan kelonggaran maksimum di sabuk.